[ESEE] RAT AF-818 Screw Gate Locking Carabiner

 Description: 

The ESEE RAT AF-818 Locking Carabiner is the go to climbing, canyoneering, caving, and light rescue carabiner used by the Randall's Adventure and Training crew. It's is tested in accordance with EN 12275: 1998 and is ready for action. 24kN major axis; closed gate. 8kN major axis; open gate. 8kN minor axis. 16mm gate opening. Basic connector that's used by the RAT team.

APPLICATION

This connector (AF-818 carabiner) is personal protective equipment (PPE) used for recreational climbing, caving, canyoneering and rappelling, EN 12275:1998 class B (basic). This product should not be used for any purpose other than that for which it is designed. If this connector is used for other purposes than for which it is designed, it must be removed from service for use as a life safety connector.

WARNING

Activities that require the use of this equipment are inherently dangerous. You are responsible for your own actions as well as understanding the proper use and application of this equipment.

Before using the equipment, you should understand all instructions for use and receive proper training. Failure to heed these warnings may result in severe injury or death. If you do not understand how to use this equipment, or if you have not been properly trained, DO NOT use this equipment.

BEFORE EACH USE

Inspect the equipment before each use. Verify that the frame, gate, rivet holding the gate, and locking sleeve are free of any cracks, corrosion or deformation. Verify that the gate works freely and engages properly into the keyhole. Verify that the locking sleeve can be screwed to the closed and opened positions without interference.

USE

Verify the connector is always loaded on the major axis. Do not side load. Verify the locking sleeve is locked (screwed closed so the gate will not open). Avoid any contact that would cause damage to the gate, or unscrew the locking sleeve. Verify the connector is compatible with any device it is connected to. Do not triaxial load or minor axis load the connector – load the major axis only. This connector must be used with the gate closed and the sleeve locked. If you do not understand any of these instructions, DO NOT USE the connector. 

REMOVE FROM SERVICE

If this connector receives a hard shock load in a static system, or any load greater than normal use, it should be removed from service. If this connector is dropped on to a hard surface, it should be fully inspected, then removed from service if there is any doubt on whether it was damaged. If this connector is used for any non-PPE use (such as towing a vehicle), it must be removed from service as life safety PPE.

MAINTENANCE

After every use, the connector should be inspected and cleaned before being stored. Clean with warm water and a mild brush, allow to dry and store in a dry location away from harsh chemicals or moisture.